service

If you want to use the whirlpool, please let us know in advance so that we can turn on the heating. We will then activate the whirlpool heating for you with the desired number of degrees. The heating mode takes up to 30 hours and we activate it before your arrival so that you can use the whirlpool in the afternoon from the day after your arrival. The whirlpool is adjusted in such a way that it reaches the desired bathing temperature every day from the early afternoon and keeps it until late at night. When the target temperature is reached, the heating switches off automatically and becomes active again as soon as the target temperature has fallen below by 0.5 degrees.

During the night it cools down naturally and in the morning the water temperature has not yet reached a warm level.

We chose these heating settings for energy efficiency reasons. However, if you want to use the whirlpool in the morning, please let us know and we will leave the heating on all the time. However, higher power consumption values can then be expected.

For bathing, please remove the covers, the whirlpool is then ready for bathing. When entering on the right, the interior light and the bubble pumps can be controlled using a three-way switch (all low-voltage and therefore harmless). The first switch coming from the entrance is for the light, the other two are for bubble pumps. When using the whirlpool lights at night, please note that this will attract more mosquitoes.

water care

The pool is controlled with a digital and fully automatic system. This regulates the filter times as well as the pH and chlorine level of the whirlpool. If irregularities should occur here, messages are automatically sent to us.

If, contrary to expectations, you should notice a discoloration of the water, please contact us immediately via whatsapp!

water level

In the summer months, a small amount of water is automatically refilled every day to compensate for evaporation. This is difficult to calculate in hot months and we have had bad experiences with sensors.

If you should find that the pool has too little water, please fill it up with the water hose lying on the property.

Dirt in the hot tub

It is unavoidable that the wind will blow leaves and other particles into the whirlpool. Therefore, please always leave the covers on the pool when you are not using it for bathing.

If small objects fall into the whirlpool, these are usually vacuumed up while the pump is running, if not, please remove them with the net.