Pool cleaning robot Dolphin F 50
The pool robot ensures a clean pool and sucks dirt such as leaves etc. out of the pool. Please only use the robot when you are not in the pool. Although the device works with low voltage, we expressly point out that you should remove the robot from the pool when you enter the pool. We recommend leaving the pool robot running overnight.
Insert pool cleaning robot
To insert the robot, take the Dolphin by the wide handle and place it in the water. In a few seconds it fills with water and sinks to the bottom. Please put enough blue cable into the water so that it can clean the entire pool.
Switch on the pool cleaning robot
Then switch on the robot at the gray box. It then runs its cleaning program of approx. 2 hours and then switches itself off on its own. If it won't turn on (small blue LEDs light up on the power button), please
unplug the power cord, plug it back in after 1 minute, and then turn on
Then wait until the pool robot has made its rounds and cleaned the pool floor. This usually takes 2-3 hours.
Switch off the pool cleaning robot
To remove, you can pull the robot towards you using the cable, but always remove it using the handle, the cable cannot withstand the pull. Before removing, please make sure that it is switched off, if in doubt pull out the mains plug.
Cleaning the pool robot
If the pool robot can no longer pick up everything from the floor, the bag is probably in front and it should be cleaned. Please follow the following instructions using pictures or the YouTube video.
Contact via Whatsapp ( 49 176 476 13557)
Contact by E-Mail(casa-albero@outlook.com)
