Panorama sauna with glazed front

Costs of use and billing

The costs consist of a one-off basic fee per stay of €20 (only when used) and a consumption-based usage fee, currently €0.60 per kwh.

By issuing the code for the key safe for the sauna, the €20 user fee and the ongoing electricity costs due to use are incurred. If there are two guest parties on the facility, we will charge the costs to the party who had the sauna unlocked first and thus received the key. If both parties want to use the sauna, any offsetting between the two parties must be agreed individually - the digital counters allow our guests a transparent allocation among themselves. Please understand that we cannot make this division as we do not know who is using the sauna and when.

You will be informed of the costs incurred upon departure and must be paid in cash.

Activation, access and rules of use

If you want to use the sauna, please let us know. We will then give you the code for the key safe in the fitness room labeled Sauna. The key for the sauna door is in this safe.

Please refer to our house rules for the rules of use.

operation manual

1) Key for sauna in fitness room 1

In fitness room 1 (accessible from the outside on the right side of the house on the ground floor through fitness room 2) there are small key safes on the wall next to the entrance door.

Enter the 4-digit code on the safe for the sauna and press down the small silver-colored lever to the left of the number entry. You can then remove the key. Please put the key back in the safe after you have finished using the sauna.

2) Activate sauna in fitness room 1

The power supply of a house connection in Italy is significantly lower than a German house connection. In Casa Albero there are many consumers with high load behavior (air conditioning, pool heating, whirlpool and sauna). For this reason, the whirlpool, pool heating, pool counter-current system and sauna cannot be switched on at the same time. By default, the whirlpool, pool heating and counter-current system are activated, the switch (photo on the right) is set to "0", as can be seen in the picture.

When using the sauna, the switch in the fitness room must be turned to position 1 (= sauna) in order to be able to use the sauna. After the end of the sauna session, the rotary control must be set back to position 0 (= whirlpool and pool heating / pool counter-current system). Of course, the whirlpool can be used between sauna sessions – but the air and water massages and the heating of the whirlpool are deactivated when the switch is in position 1 (=sauna).

Please make sure that nobody is using the whirlpool at the same time, otherwise the pumps would be deactivated.

3) Switch on the sauna in the sauna

The black control module is located below the light switch.

1. Press the lower knob (circle) of the control module once. You can see the actual temperature in the middle and the target temperature at the top right. You can use the rotary control to adjust the target temperature.
2. Confirm the desired temperature by pressing the control dial again and the control module switches to heating mode. Recognizable by the three waves above the actual temperature in the image below.
3. The sauna is switched off again by pressing it again